Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a little, but it still feels attractive. peugeot 308 key fob replacement www.g28carkeys.co.uk 's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent, the following tips should assist.
Water Damage
If you accidentally drop your key fob in an eddy, or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. The best method to prevent this from happening is to always keep it in a dry bag when you're going outdoors or doing activities that require the fob to be exposed to large amounts of water.
You'll also want to ensure that the fob is completely dry prior to opening it and using it again. If you detect any smells coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another sign that it's submerged in water.
A wet circuit can cause the battery's charge to be drained or even explode. If you can remove your 308 keyfob out of the water it is best to turn the button side up and shake as much water out as possible before opening the casing. Take the battery out, and then wipe the circuit board clean using a cotton swab which has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not work include a dead coin cell battery or receiver module issues signal interference, or a defective chip. If none of these are the issue you can reset the system by disconnecting the 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start systems that lets drivers start their vehicle from an extended distance, which allows them to warm up or cool down the vehicle before they enter. This feature is extremely useful particularly during the cold winter months. However, sometimes the remote start system ceases working due to a variety of causes, such as the battery in the coin is dead.
A coin-shaped battery that is in the key fob has a life span of between two and four years, based on how often it is utilized and where it was purchased. The date of use will be written on the packaging or in the user manual.
If the key fob has stopped functioning after being exposed to water that is clean, remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have fried the chip. You will need to replace it.
If you're not certain the battery is faulty, you can test its voltage with a multimeter that is set to the car's voltage range, and connect it to the terminals for minus and plus. The voltage should be between 12 to 13 volts, however, if it reads lower, the battery should be replaced. You can also try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you aren't seeing the "Key Detected" message, it could mean that your receiver module is faulty. It's that part that sends an alert to the car when your key fob is activated that also acts as an immobiliser. It stops it from starting until the correct key is in place.
This could be caused by many factors, including water damage or just aging. If the electronic chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was exposed it. In this instance you'll have to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the problem persists it is recommended to visit the local Peugeot expert or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and repair it for you.
The loss of your Peugeot car keys can be an incredibly stressful experience. However, a qualified auto locksmith can resolve the issue in only a few minutes. They can program your car and cut a fresh, working key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If it is damaged your car might not start, or you could get a message saying "anti-theft active". In this instance, the only solution is to replace the key. Luckily, auto locksmiths who are professionals can complete the task within the shortest period of time.
The chip in your Peugeot 308's key fob may fail due to different reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. You can make use of a towel and isopropyl alcohol to wipe the electronic component. The battery must then be allowed to fully dry.
Sometimes, a key fob can not function due to radio interference. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. This could be due to bad conditions or objects close to the vehicle. If you have this issue it is advised to visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is very delicate and requires special care. It should not be dropped or throw it around. If you lose something, try to find it as soon as you are able to. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Be sure to disconnect the negative cable first, then the positive.
